Gain staging: top of the green

Set the trim so meters sit at the top of the green, touch amber briefly, and never sit in red.

Beginner7 min readReviewed 17 Nov 2026

The Mixxx manual puts it simply: meters should mostly sit around the top of their green region, the average level should not be in yellow, short peaks may briefly touch yellow, and if a meter is in red the signal is clipping and the gain should come down [1].

  1. 01Push the channel fader all the way up.
  2. 02Play the loudest part of the track.
  3. 03Turn the trim up until the channel peaks just below red [2].
  4. 04Leave the software master around 12 o'clock and never at maximum [2].
  5. 05If the master meter goes red, turn the channel trims down, not the master [3].
Average level to aim for: the top of the green [2]
~0 dB
Where short peaks may go, briefly [1]
Amber
Clipping. Turn the trim down [1]
Red
Where to leave the software master [2]
12 o'clock

Clipping at any stage distorts, even if every stage after it is clean, and at worst it can damage speakers [2]. In a club the house system has already been gain-staged and is protected by limiters, so keeping your mixer just below red sounds better than pushing into it. Keep some headroom in reserve too, because a full room absorbs more sound than an empty one [2].

Practice it now

Two decks in your browser. No download, no account.

Open the decks

Sources

  1. [1]DJing with Mixxx (manual 2.5) · Mixxx
  2. [2]Gain staging for DJs: staying out of the red · DJ TechTools
  3. [3]Setting Rane mixer level controls · Rane